•
•
1
2
3
4
No daily maintenance is required. However
, filter should be cleaned
if the dirt is noticeable due to the environment in which the air
conditioner is used.
stainless mesh filter
Stop the operation with the remote
controller
and unplug the power plug
(or turn off the circuit
breaker).
Open the front panel.
(Refer to page 8 on opening the front panel)
Remove the front panel.
PushPush
Arm
Arm
Push the end of the right-side arm outward to
release the tab.
Move the left-side arm outward to release the
left tab, and then pull the panel towards you.
DEUTSCH
FRANÇAIS
ITALIANO
SPANISH
PORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
Maintenance of Stainless Mesh Filter
Remove the front stainless mesh filter.
Filter locks
Hold this part to pull it out
Slide the left and right stainless filter locks
towards the direction as illustrated.
Slightly lift up the stainless mesh filter
and pull it out towards you.
– 35 –
ENGLISH
18SH3_OM.indd 35
18SH3_OM.indd 35
2012-2-21 14:45:412012-2-21 14:45:41
5
6
7
8
9
MAINTENANCE (continued)
Maintenance of mesh stainless filter (continued)
V
acuum the dust.
•
In the event the stainless
mesh filter is heavily dirty and the dust cannot
be cleaned with a vacuum cleaner, wash the filter with neutral detergent
and rinse well with water
, and then dry the filter in the shade.
•
Align the filter with the top face of the indoor unit, and then slide and push it in.
(The shape of the left and right filters is the same.)
•
Tighten the left and right filter locks to the indicated direction.
Attach the front panel.
Insert the shaft of the left arm along the step on the unit into the hole.
Securely insert the shaft of the right arm along the step on the unit into the hole.
Make sure that the front panel is securely attached, and then close the front panel.
Close the front panel.
(Refer to page 9 on closing the front panel)
Turn on the power supply (or turn on the circuit breaker).
•
Improper installation of the micro mesh stainless filter could result in malfunction. Filter cleaning
operation can not be performed properly and the
(CLEAN) indicator blinks.
•
Do not operate the air conditioner without the micro mesh stainless filter
.
Dust goes in the gap of the heat exchanger as well as inside the appliance and may cause unpleasant smell
on the heat exchanger or could result in malfunction.
•
Be extra careful not to cut your hand with the fin of the heat exchanger when removing and reattaching
the micro mesh stainless filter
.
CAUTION
Attach the stainless mesh filter.
– 36 –
18SH3_OM.indd 3618SH3_OM.indd 36
2012-2-21 14:45:422012-2-21 14:45:42
Summary of Contents for RAC-10SH3
