2. CLEANING OF FRONT PANEL
Remove the front panel and wash with clean water.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with
clean water.
When front panel is not removed, wipe it with a soft
dry cloth. Wipe the remote controller thoroughly with
a soft dry cloth.
Wipe the water thoroughly.
If water remains at indicators or signal receiver of
indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to
detach and attach it.
CAUTION
Removing the Front Panel
Attaching the Front Panel
Do not splash or direct water to the body of the unit when cleaning it as
this may cause short circuit.
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a
brush, because they will damage the plastic surface and the coating.
BENZINE
THINNER
A
C
I
D
Push the end of the right-side arm outward to release
the tab.
Move the left-side arm outward to release the left tab,
and then pull the panel towards you.
Insert the shaft of the left arm along the step on the
unit into the hole.
Securely insert the shaft of the right arm along the
step on the unit into the hole.
Make
sure
that
the
front
panel
is securely attached,
and then close the front panel.
1.
2.
1.
2.
3.
1
2
Push
Arm
Arm
