5
No.
Key Name
Function
8
(3)
·The key is used to move left.
·It moves to the previous mode when the display is navigation layer.
9
(4)
·The key is used to move right.
·It changes display mode from one to another when the display is
navigation layer.
10 FWD
RUN
Motor runs forward. The key is used for operating motor only when
operation command (A002) is set in operator or the compulsion
operation function is effective. (Check KEY ENABLED LED, whether
it is flashing or not.)
11 REV
RUN
Motor runs reverse. The key is used for operating motor only when
operation command (A002) is set in operator or the compulsion
operation function is effective. (Check KEY ENABLED LED, whether
it is flashing or not.)
12 STOP/RESET
The key is used to stop the motor, or reset an alarm. It is also
possible to invalidate the STOP key when setting parameter. The
key does not response when WOP reads or writes the parameters
from or to inverter.
2.3
Initialize Inverter
According to the following procedure to initialize inverter via WOP.
Inverters
Initializing procedure
WJ200 series
（
Ver.2.0 or above
）
Set parameter “b180” (Please refer to inverter instruction
manual)
X200 series
（
1
）
set parameter b084/b085.
（
Please refer to inverter instruction
manual
）
（
2
）
Press [ESC] and [
] key, then press [
] key.
（
3
）
Release [
] key at first then release [ESC] and [
] keys
SJ700/L700 series
（
1
）
set parameter b084/b085.
（
Please refer to inverter instruction
manual
）
（
2
）
Press [ESC] and [
] key, then press [
] key.
（
3
）
Release [
] key at first then release [ESC] and [
] keys
NE-S1 series
Set parameter “b180” (Please refer to inverter Quick Reference Guide)
Chapter 2
Name of parts and functions of WOP
