245
RHUE-(3~6)A(V)HN
SMGB0066 rev.0 - 12/2009
Servicing
Service Manual
9
9.1.8. removing high pressure switch
Remove the service cover according to the section
1.
“Removing service cover” in this chapter.
Collect the refrigerant from the check joint according to
2.
the section “Removing the compressor” in this chapter.
Disconnect the faston terminals from the pressure
3.
switch.
Cut the high pressure switch from the brazing neck
-
using a burner.
warning
High pressures. Explosion risk.
-
Do not change the high pressure switch locally or
-
change the high pressure cut-out set value locally. If
changed, it will cause serious injury or death due to
explosion.
Do not attempt to turn service valve rod beyond its stop.
-
High pressure
switch
Terminals
High pressure switch structure
Contact point
Pressure detection
Faston terminals
