●
Set the print specifications 4-61
When the nozzle is positioned before the sensor
When the nozzle is positioned after the sensor
Print start delay=a-b (mm)
Print start delay=a+b (mm)
Printing method
●
Two printing methods are selectable: "single scan" and "interlaced"
●
A printing method will be automatically selected in accordance with the print format setup.
●
When making interlaced prints, perform the following setup.
(i) Ensure that the same print format is employed for all items.
(ii) Ensure that the same line count setting is employed for all columns.
(iii) The ink drop use percentage is 1/1 to 1/4.
Perform overall column setup. The format for the first item is
then applied to all the other items so as to provide interlaced
setup. When making a 1-line print, the single scan predominates
even if you perform steps (i) through (iii) .
5
Print start delay
●
The printing start position can be specified.
●
After setting in character units or mm units, fine adjust in scan units.
●
When you want to input in mm units, input “Line speed”.
●
The positional relationship between the sensor and nozzle is as indicated below.
6
Setting
Direction of transport Printing results
0 : A B C
a
←
A B C 1 2 3
→
→
b
1 : A B C
a
←
←
→
b
A B C 1 2 3
2 :
a
←
←
→
b
3 :
a
←
→
→
b
) * + !
)*
+
!
ＡＢＣ123
Character orientation
●
Printing direction of characters can be set.
●
Settings and print results are as shown below.
4
●
Specify the print start delay (printing start position) as suggested below.
(i) Measure the length of the print start delay.
(ii) Measure the inter-character distance (C).
(iii) Divide the value obtained in (i) by the value obtained in (ii). Enter the resulting value.
a+b
c
: Setting value
●
When a product speed matching function is not provided, if the ink drop use percentage, character
width, character size or number of lines is changed, the set value of the print start delay can be adjusted
so that the time until printing starts will not change.
●
When a product speed matching function is provided, if the pulse rate division actor is changed, the set
value of the print start delay can be adjusted so that the time until printing starts will not change.
A B C 1 2 3
A B C
A B C
A B C 1 2 3
)*
+
!
) * + !
Direction of transport
Example of setting "0:ABC
→
"
and Direction of transport "a".
Sensor
c
Direction of transport
Print target
b
Nozzle center
a
a
b
0 0 2 3
Sensor
c
Direction of transport
Print target
b
Nozzle center
a
0 0 2 3
Summary of Contents for RX
Page 188: ...2 J0808 2C ...
