4-64
●
Set the print specifications
4.13.2 Set repeat printing
(1)Overview
●
This is set to print the same print description continuously.
●
Set the "Repeat intervals" and "Repeat count" for repeat printing.
Repeat intervals
●
The print target size can be specified.
●
This setup is to be performed when the print target is transported while it is in close contact.
●
After setting in character units or mm units, fine adjust in scan units.
●
When you want to input in mm units, input “Line speed”.
●
Perform the following calculations for repeat intervals setup purposes.
(i) On an individual scan basis
(1-digit character width × number of digits - trailing character correction value)
× (print target size/all-digit print width)
(ii) On an individual character basis
Number of digits × (print target size/all-digit print width)
1
●
1-digit character width = (horizontal character size + inter-character space) x character
width increase setting
●
Trailing character correction value = inter-character space x character width increase
s 1
(Example) Print target size: 64 mm; all-digit print width: 25 mm;
number of digits: 6; character size: 5 × 7 dots; inter-character space: 2 dots
●
On an individual scan basis
((5+2)×1×6-(2×1+1))×(64/25)=99.84
→
100
●
On an individual character basis
6×(64/25)=15.36
→
15
●
Round off the calculation results to the nearest whole number.
Repeat count
●
You can preset the number of repeats.
●
If repeat printing is not needed, set the number to "0".
●
Printing is performed in accordance with the repeat printing mode setup.
●
The relationship between the repeat printing mode and the count is as stated below.
2
Mode
Setting
2 to 9998
9999
Signal ON
period
Printing is repeated a preselected
number of times at predefined
intervals while the print target is
detected.
Repeat printing is performed
while the print target is detected.
OFF - ON
transition
Printing is repeated a preselected
number of times at predefined
intervals once the print target is
detected.
Once the print target is detected,
repeat printing is performed until
it is aborted.
Print target
Print target
Repeat intervals
Summary of Contents for RX
Page 188: ...2 J0808 2C ...
