8
How to Install the Washing Machine
Connecting to the tap
●
The symbol is for checking whether you install the washing machine correctly.
●
Water supply hose
The optimum water pressure is 0.03 to 0.8 MPa.
Horizontal tap
Extension tap
Water Inlet valve
Water supply hose
Connect the water supply hose to the water inlet
valve on the washing machine.
Rubber seal
Hose connector
Check that the rubber seal is in the hose
connector.
Make sure the union nut between the water supply hose and the washing machine is
fi
rmly tightened.
Before operating the washing machine, open the tap to con
fi
rm that the water supply hose is correctly
connected. If the union nut is loose, water will leak.
●
Water supply hose with one-touch joint
1. Loosen the top connector.
Top connector
Rubber seal
Fixing screw
Bottom connector
Connector ring
●
If the diameter of the tap is larger than
the connector ring, remove the ring.
2. Press up on the top connector so the rubber seal
and the tap are
fi
rmly sealed. Next, tighten the
4 screws.
Top connector
Rubber seal
Bottom connector
●
Rotate the bottom connector so there is no water
leakage.
●
Close the tap so you can remove the water supply
hose from the bottom connector. Next, pull o
ff
the
hose and lower the clasp.
3. Attach the water supply hose to the bottom connector and lower the clasp.
Bottom connector
Slide bushing
Water supply hose