$
$
String
→
(Front or side)
Weight
9
How to Install the Washing Machine
●
The symbol is for checking whether you install the washing machine correctly.
1. Installation of Washing Machine
Move the Washing Machine to the setting area.
Connect the Washing Machine correctly to a grounded AC power supply.
The voltage of the power supply must match the voltage rating of the Washing Machine.
Do not use extension cords or overload the power outlet by using power strips.
2. Check the horizontal level
According to the
fi
gure on the right, check the level by using
a simple jig which can be made with string, pen and weight
such as coin.
If the gap between A and
are same,
your Washing Machine is well leveled
(± 5mm).
3. Check the level
If the Washing Machine is not stable or when the
fl
oor itself is not leveled, please adjust the leg.
Lock nut
Lock
nut
Loosen lock nut
Adjust leg height
Tighten lock nut
Adjustable leg
Raise this leg
Lower this leg
Adjustable leg
Foot
Caps
Rotate the lock nut in the direction
of the arrow to loosen it and then
rotate the adjustable leg to stabilize
the Washing Machine.
When the adjustment is
fi
nished,
rotate the lock nut in the direction of
the arrow to tighten it.
4. Check the center of tub
When the Washing Machine is leveled, please also make sure that
the washing tub is positioned approximately in the center.
Note :
Failing to do so may cause a vibration or abnormal operation.
Checking after installation
If any of the following problems or other abnormalities occur, immediately unplug the power plug and
contact your local service center.
The Washing Machine does not operate when the power is turned on.
The power cord is damaged.
There are abnormal vibrations or sounds during operation.
There is a smell of burning.
Check the di
ff
erence
between left and right