25
Problem
Thing to check
Instructions
Washing Machine
fails to operate
Is the power plug not inserted in the
power outlet?
Insert in the power outlet.
Is there a power outage?
Check your other product in your
home.
Is the Delay Timer set?
Please check this function.
Washing Machine
is wet, even
though it is the
fi rst time to use it
(drain hose, tub,
etc.)
At factory, we are checking the actual
performance of each product before
shipment. Some water drops might
remain in the product, but this is not
a malfunction. We ask for your kind
understanding.
Please clean with a soft cloth for Tub
drying.
The remaining time
increases during
operation
Is remaining time adjusted to
compensate for the speed of the
incoming water?
Adjust water volume to high speed.
Water is added
again during the
washing process
Is water added automatically up to the
set water level if the water level falls
because water is absorbed by the
laundry?
To keep the preset water level, water
may be added during operation.
Wash time is
longer than the
time that was set
manually
Is the water pressure low?
The operating time may increase
due to a longer water supply time,
depending on the pressure level of
tap water.
The washing
machine stops
during the spin
cycle and starts
adding water
Are loaded clothes unbalanced?
If the laundry is extremely o
ff
balance
when the spin cycle starts, the spin
cycle stops and the rinse cycle starts
to rebalance the laundry. After the
load is rebalanced, the spin cycle
starts again.
The lid does not
open
Is the lid locked?
When the lid lock indicator is on, lid is
still locked for your safety.
Cannot be opened because there
was a power outage or the power was
turned o
ff
while the lid lock indicator
was lit. Turn on the power and wait for
the lock to be released.
The display screen
becomes foggy
This is not the failure.
The fog disappears in approximately
24 hours and it does not a
ff
ect the
operation.
Troubleshooting
Summary of Contents for SF-P130TCV
Page 32: ...3WPL133481 ...
