Getting Started (Initial Setup)
20
Once channels are preset, you can use the up and down CHANNEL
buttons to move through the active channels. Or you can press the
number buttons to move quickly between channels that are far apart.
Removing Channels
You may not want to keep all the stations the auto-programmer selects,
since you may prefer to have only a few favorite channels in the tuner's
memory. Or, you may want to delete from memory a weak or unused
channel that the tuner picked up.
Erased channels cannot be selected by the up and down CHANNEL
SELECT buttons but can still be selected by using the numbered buttons 0
to 9 and 100/ENT.
Adding Channels
Occasionally the auto-programming may skip an active channel because
the antenna was pointed in the wrong direction or the channel had a weak
signal or was "off the air" at the time of programming. Or you may change
your mind about a channel you removed from memory.
To Add or Erase Channels
Press GUIDE, then press 4 to bring up the Setup screen. Item 5 in
setup screen lets you add or delete channels. Use the number buttons to
enter the channel you want to change, then press STOP to delete it or
press PLAY to add it.
Caution After a Power Failure
If a power failure lasting for more than 1 minute occurs, reset the clock and
perform the "AUTO CHANNEL SET" found in the "SET-UP" menu.
Summary of Contents for SIDE BY SIDEREFRIGERATOR
Page 44: ...Specifications 44 ...
