--- 9 ---
3. Pull out the Dust Seal
[25] <25>
from the armature shaft.
(3) Replacement of the Stator Ass'y
[23] <23>
Model SP 18VB:
1. Pull out Armature (A)
[15]
, then pull out the Fan Guide
[16]
from the Housing Ass'y
[27]
.
2. Loosen the Tapping Screw (W/Flange) D4 x 20 (Black)
[52]
and remove the Tail Cover
[51]
, Grip Cover
[53]
and Handle Cover
[35]
.
3. Loosen the Machine Screw (W/Washer) M3.5 x 6
[36]
and remove the blue Terminal
[38]
connected to
Switch (A)
[40]
.
4. Cut the internal wire connected to the blue Terminal
[38]
and the internal wires connected to the two
Connectors
[39]
with nippers.
5. Remove the Controller
[30]
from the Housing Ass'y
[27]
.
6. Remove the Brush Terminal
[24]
from the Brush Holder
[31]
.
7. Remove the Hex. Hd. Tapping Screw D5 x 45
[22]
and remove Stator Ass'y (A)
[23]
from the Housing Ass'y
[27]
. If it is difficult to remove Stator Ass'y (A)
[23]
from the Housing Ass'y
[27]
, heat the Housing Ass'y
[27]
to about 60
û
C to make the removal work easier.
J-204 Bearing Puller
(Code No. 970982)
J-130-2 Sleeve
(Code No. 970908)
Fig. 11
Model SP 18SB:
1. Pull out the Armature
<15>
, then pull out the Fan Guide
<16>
from the Housing Ass'y
<26>
.
2. Loosen the Tapping Screw (W/Flange) D4 x 20 (Black)
<50>
and remove the Tail Cover
<49>
, Grip Cover
<51>
and Handle Cover
<30>
.
3. Loosen the Machine Screw (W/Washer) M3.5 x 6
<31>
and remove the Terminal
<28>
connected to
Switch (A)
<34>
.
4. Cut the internal wire connected to the Connector
<33>
with nippers or loosen the screw of the Pillar
Terminal
<41>
and disconnect the internal wire of Stator Ass'y (C)
<23>
from the Pillar Terminal
<41>
.
5. Remove the Brush Terminal
<24>
from the Brush Holder
<37>
.
6. Remove the Hex. Hd. Tapping Screw D5 x 45
<22>
and remove Stator Ass'y (C)
<23>
from the Housing
Ass'y
<26>
. If it is difficult to remove Stator Ass'y (C)
<23>
from the Housing Ass'y
<26>
, heat the Housing
Ass'y
<26>
to about 60
û
C to make the removal work easier.
Push
Summary of Contents for SP 18SB
Page 27: ......
