Pay attention so that the cable may not be bitten. It may cause a faulty operation.
CAUTION
Remove the protection film
4 Insert the hooks of the controller to the holes on the top of the holding bracket. Push the lower part toward the holding bracket.
When the click sound is heard, the remote controller is attached to the holding bracket and the mounting work is finished.
Be careful not to pinch the cable when attaching it.
Remove the protection film from the liquid crystal display.
Lead the cable along the slot.
Cut and make a draw-out hole.
*Extended cable is prepared as an option. (SPX-WKT5M : 5m)
This cable can add until 2 pcs.
3 Cut the top of front cover and make a draw-out hole.
Lead the cable along the slot.
Fix the holding bracket with
the mark “UP” upward.
2 Attach the remote controller to holding bracket as follows.
Fix the holding bracket onto wall with screws(accessory) as shown right.
Groove for attaching controller
Rear cover
Figure seen from bottom side
Slotted Screw driver
Approx. 6mm
Groove
1 Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and then remove the remote controller
from holding bracket.
2.3 INSTALLATION PROCEDURES
English
- 3 -
Summary of Contents for SPX-WKT2
Page 8: ......