--- 6 ---
8. PRECAUTIONS IN DISASSEMBLY AND REASSEMBLY
The
[Bold]
numbers in the descriptions below correspond to the item numbers in the Parts List and exploded
assembly diagram.
8-1. Disassembly
(1) Removal of the Armature
[25]
and the Stator
[22]
Remove the four Machine Screws M4 x 10
[18]
, and remove the surrounding parts such as the Pad
[17]
, Base
[16]
and Felt
[34]
.
Remove the two Tapping Screws (W/Flange) D4 x 16
[33]
, and remove the Fan Guide
[32]
.
Keeping a screwdriver inserted into the clearance of the Balance Fan
[27]
, remove the Seal Lock Flat Hd.
Screw M4 x 12
[31]
. Remove the Washer
[30]
, Ball Bearing 6001DDCMPS2L
[29]
, Dust Washer
[28]
and
Balance Fan
[27]
.
Remove the four Tapping Screws (W/Flange) D4 x 20 (Black)
[2]
, and remove Housing (A).(B) Set
[3]
.
Remove the Carbon Brush
[13]
together with the Brush Holder
[12]
. Lift the Stator
[22]
and pull out the
Armature
[25]
.
After pulling out the Armature
[25]
, disconnect the Internal Wire (Brown)
[5]
, Internal Wire (Blue)
[24]
, Tab
Terminal (Blue)
[6]
and Tab Terminal (Brown)
[23]
from the terminals of the Stator
[22]
. Then pull out the
Stator
[22]
.
8-2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
(1) Assembly of the Dust Washer
[28]
Be sure to mount the Dust Washer
[28]
in correct direction as shown in Fig. 1. Otherwise, the Ball Bearing
6001DDCMPS2L
[29]
can be damaged at an early stage.
Fig. 1
Dust Washer
[28]
Ball Bearing 6001DDCMPS2L
[29]
1
2
3
4
6
