Chapter 12. When Warning or Fault Occurs
12-6
Fault message list (faults that stop the ink jet) (Continued)
Message
No.
Message
Message description
Solution
E-010
Makeup
Replenishment
Time-out
Automatic makeup refilling takes long.
●
Contact your nearest local
distributor.
E-011
Makeup Low Fault
Printing cannot continue because the
makeup reservoir is almost empty.
(If the makeup is not refilled within 60
minutes after the warning, the warning
changes to the fault, stopping the unit.)
●
Replace the makeup cartridge.
(
8.2.)
E-012
Ink Heating Unit
Temperature Too
High
The ink heating unit is too hot.
●
Contact your nearest local
distributor.
E-013
Multi DC Power
Supply Fan Fault
The cooling fan of the multi DC power
supply is abnormal.
After stopping the ink ejection, the unit
will be automatically shut down.
●
Contact your nearest local
distributor.
E-014
Charge Voltage Too
Low
The charging voltage supplied from the
high-voltage power supply unit to the
nozzle drive board EZJ142 is too low.
●
Contact your nearest local
distributor.
E-015
Charge Voltage
Fault
The charge voltage cannot be output
properly.
●
Check if there is any electrical short
circuit between the charge electrode
and other parts.
E-016 No Ink Drop Charge
The ink drop charge cannot be detected.
●
Make sure that the ink stream is
nearly at the center of the gutter.
●
Clean the gutter, deflection
electrode, and its surroundings.
●
Check the ink pressure.
(
Technical Manual 5.9)
●
Adjust the excitation V-ref. value so
that ink drops are produced better.
(
Technical Manual 5.10)
●
Make sure that the ink stream has
been correctly recovered.
E-017
Ink Heating Unit
Temperature Sensor
Fault
The detection temperature of the ink
heating unit is abnormal.
●
Contact your nearest local
distributor.
E-020 Memory Fault M
The memory data has a fault.
●
Contact your nearest local
distributor.
(Continue to next page)
Summary of Contents for UX2 Series
