SET UP FOR USE
33
correct time.
• When unplugging the AC-cord or if there is a power failure for more than 30 seconds,
you may have to reset the clock.
• If the display shows an abnormal reading or no reading, unplug the power cord for
more than 30 seconds. Then plug it back in and reset the clock.
TO CHANGE CLOCK SETTING
1) Press MENU button until the INITIALIZE menu appears.
2) Press the PLAY/
or STOP/
button to point to "SETTING CLOCK". Then, press
the F.FWD/ button.
INITIALIZE
CHANNEL SET UP
SETTING CLOCK
LANGUAGE
SELECT
3) Follow steps [2] to [8].
TO DELETE OR ADD CHANNELS
The channels you no longer receive or seldom watch can be deleted from the memory.
(Of course, you can later add the deleted channel into the memory again.)
• Use the remote control for this procedure.
• Be sure to check that the POWER and the VCR/TV indicators are both on.
• Turn on the TV and set the TV to channel 3 or 4. Now set the CH3/CH4 switch on the
back of the VCR to match the channel selected on the TV.
1 Select "INITIALIZE"
Press MENU button until the INITIALIZE menu appears.
2 Select "CHANNEL SET UP"
Confirm "CHANNEL SET UP" is pointed to, then press the
F.FWD/ button.
INITIALIZE
Summary of Contents for VT-MX4410A
Page 5: ...CAUTIONS 5 ...
Page 22: ...PREPARATION FOR USE 22 ...
Page 26: ...PREPARATION FOR USE 26 ...
