Getting Started (Initial Setup)
26
and back to <AUTO>.
<AUTO>:
The daylight savings time (D.S.T) is set automatically.
<ON>:
The time advanced from the Standard Time by one hour is displayed from the
first Sunday of April through the last Sunday of October.
<OFF>:
The Standard Time is displayed throughout the year.
This screen gives an example where <ON> is specified.
4. Press 2 and set the time again.
If the displayed time drifts from the current time by more than one hour even after steps 1 - 4
have been performed, change the D.S.T option again in step 3, then set the time again.
To set the clock manually
1. Press GUIDE, then press 3 to bring up the CLOCK SET screen.
Press 1 to switch "CLOCK SET <AUTO>" of item 1 to "CLOCK SET <MANUAL>".
If "CLOCK SET <MANUAL>" is specified in item 1, "SET TIME ZONE" of item 3 and "SET
D.S.T" of item 4 are not displayed.
2. Press 2 to bring up the following screen.
Press the number buttons on the remote control to set the current time - two digits for the hour
and two for the minutes. Then press 1 or 2 for AM or PM, respectively.
For example, if it is now 2:15 PM, press 0, 2, 1, and 5 for hours and minutes, and press 2 for
PM.
Continue pressing buttons to set the date. For example, if today is July 8, 1996, press 0, 7, 0,
8, 9, and 6 to get 07/08/96.
When you're done, press GUIDE to return to regular viewing.
Tips:
The white dash " - " appears for the item to be changed on the screen as you proceed.
The clock uses the 12-hour system. You set it for AM or PM.
An illogical time (like 13 for the hour or 20 for the month) will not be accepted.
If you press the wrong digit, exit the screen by pressing GUIDE and recall the screen to
enter the correct setup.