--- 25 ---
(2) Removal of Front Cap (B)
[5] <1>
and Protector (C)
[6]
<2>
Insert a small flat-blade screwdriver between Front Cap (B)
[5] <1>
and Protector (C)
[6]
<2>
and remove
them from the Hammer Case
[8] <4>
.
(3) Removal of the Hammer Case
[8] <4>
and the hammer assembly
Remove the four Tapping Screws (W/Sp. Washer) D4 x 25 (Black)
[7] <3>
that connect the Hammer Case
[8]
<4>
to Housing (A). (B) Set
[35] <30>
and remove the Hammer Case
[8] <4>
and the hammer assembly from
Housing (A). (B) Set
[35] <30>
.
(4) Disassembly of the hammer assembly
Washer (S)
[16] <11>
Push down.
Spindle (D)
[18] <13>
Hammer Spring
(A)
[15] <10>
Stopper
[17] <12>
J-297 base for washer (S)
Fig. 8
Mount the hammer assembly onto the
J-297 base for washer (S). With a
hand press, push down the top of
Spindle (D)
[18] <13>
to compress
Hammer Spring (A)
[15] <10>
.
In this position, remove the Stopper
[17] <12>
with a small flat-blade
screwdriver, then release the hand
press. (See Fig. 8.)
Remove the hammer assembly from the J-297 base for washer (S) and support the end surface of Spindle (D)
[18] <13>
. With a hand press, push down either of the raised faces of Hammer (F)
[12] <7>
to compress
Hammer Spring (A)
[15] <10>
. In this position, extract the two Steel Balls D 5.556
[11] <6>
from the cam
grooves of Spindle (D)
[18] <13>
and Hammer (F)
[12] <7>
with a small flat-blade screwdriver and remove
them from the steel ball guide groove. Then, slowly release the hand press and lift Hammer (F)
[12] <7>
and
Washer (S)
[16] <11>
together to extract them from Spindle (D)
[18] <13>
. Hammer Spring (A)
[15] <10>
can
then be removed.
Steel ball guide groove
Spindle (D)
[18] <13>
Hammer (F)
[12] <7>
Raised faces of hammer
Top of spindle cam
Steel Ball D5.556
[11] <6>
Fig. 9
(5) Removal of the Hook Ass'y (W/Light)
[41] <36>
Remove the Special Screw M5
[49] <44>
with a flat-blade screwdriver or a coin and remove the Hook Ass'y
(W/Light)
[41] <36>
and the Hook Spring
[48] <43>
.
