OPERATOR'S STATION
1-64
2
MNEC-01-006
4. Rotate selector knob (2) to highlight Parallel/Tandem
Switching Height (6).
5. Press selector knob (2) to display Parallel/Tandem
Switching Height screen (7).
6. When the lift arm height changes by operating the lift
arm control lever, the height is displayed on segment (8).
7. When the lift arm height is within the setting range, the
mark
(9) will be displayed.
8. Press selector knob (2) to change parallel/tandem height
setting value.
9. When the parallel/tandem height setting value changes,
the value will be displayed on segment (10).
f
NOTE: When the lift arm height is below segment(10), the
operation mode is set to Parallel (Lift arm and bucket), when
the lift arm height is above segment(10), the mode is set to
Tandem (Bucket priority).
7
6
9
8
10
MNEK-01-190EN
MNEK-01-191EN
Summary of Contents for ZW 310-6
