OPERATING MACHINE
5-22
Removing Snow
d
CAUTION:
Remove snow in the same method as employed in
general loading work. However, pay attention to
slippage of tires and obstacles covered with snow.
Turn the Ride Control Switch OFF when performing
work with the front attachment in the float position.
Performing work with the Ride Control Switch ON
and the front attachment lever in the float position,
ride control is active and may allow the attachment
to drop while the machine is driving.
Precautions for removing snow
Avoid sudden starting and stopping as well as rapid
steering of the machine.
Use tire chains on all four wheels.
Pay attention to the presence of the utility facilities such fire
hydrants, manholes, curbs, roadside drains, etc. The facilities
or the machine may be damaged.
Lifting Wheel Loader
d
WARNING:
Be sure to use lifting tools and set the articulation
lock bar in the LOCK position.
Never allow any person to ride on the machine to be
lifted.
Never allow any person to enter below the lifted
machine. Before fully lifting the machine above the
ground, check that the hooks are securely attached
to the machine and the machine is well balanced
while lifting the machine slightly above the ground.
Refer to the "LIFTING MACHINE" in the
TRANSPORTING section.
Lifting work of the machine will become necessary when
loading the machine onto a ship or truck for repairing and/or
transporting.
M4GB-05-019
MNEC-05-001
Summary of Contents for ZW 310-6
