p16
p17
section 4
section 3
quadcopter preparation
transmitter preparation
Removing Blades:
Precautions:
1. Before each flight, please check that the rotor blades are correctly and firmly installed.
2. Ensure all rotor blades are intact before each flight. If the blades are worn or damaged, please replace with
new blades before flying.
3. Keep your distance from rotating rotor blades and the motor to avoid cuts and injury.
4. Use only rotor blades provided by Hitec and AEE to ensure optimal performance.
Preparing the Transmitter:
The Q-Cop 450 transmitter is used together with the quadcopter receiver. The transmitter and receiver
have been successfully adjusted to match frequency before delivery. The transmitter is set to U.S. mode as the
default factory setting mode. The repeater mount is already installed on the transmitter before delivery. Install
repeater as shown in the image below with included lock screw. Please install the mobile device mount to place
mobile devices. The mount is not suitable for use with oversized mobile devices like an iPad.
NULL
S1
S2
S3
S4
GPS
NRM
Auxillery
Wrench
Antenna
Mobile Device
Mount
3-Position
Switch S2
Transmitter
Power Indicator
Photo Capture
Indicator
Airborne Video
Capture Button
Airborne Photo
Capture Button
Left Stick
Video Stop
Button
Transmitter
Power Switch
Right Stick
Strap Hole
Video Recording
Indicator
Camera Angle
Control S3
3-Position
Switch S4
Repeater
Summary of Contents for AEE Q-COP 450
Page 1: ......
