IOM_FCW-FCCW_10a120_207995_181001_EN
USING THE CONTROL PANEL
If the appliance has a built-in control panel, raise the flap and proceed as follows.
Heating mode
Put the season selector switch from the off position ( ) to the winter position ( ). The fan starts.
In models with minimum temperature thermostat (optional), the fan starts when the internal heat
exchanger is sufficiently hot. If the water is not hot enough, the fan does not start.
Cooling mode
Put the season selector switch from the off position ( ) to the summer position ( ). The fan starts
immediately.
Selecting the fan speed
Put the selector switch to the required speed. The higher the speed the quicker the room will be
heated/cooled, although appliance operation will be noisier (Pic. 22).
Automatic temperature adjustment (for control panel with built-in thermostat)
This control panel has a built-in temperature sensor, which measures the room air temperature. This
information is used for the automatic control of the fan or introduction of water into the internal exchanger
through the solenoid valve (optional).
The appliance this keeps the room at the temperature set by the user.
The room temperature may be set approx. between 10°C and 30°C. If the appliance does not have a
built-in control panel, but is controlled by a wall-mounted thermostat, refer to the thermostat
instructions for use.
