IOM_FCW-FCCW_10a120_207995_181001_EN
FAN COIL INSTALLATION
Before installing the appliance, remove the housing (if present). Raise the flaps covering the control panel
and the water connections. Remove the two screws fixing the housing to the fan coil load-bearing
structure. Gipping the rear of the housing, remove it as shown in the Pic. 5 (NOTE: be careful of the lugs
on the front part of the load-bearing structure, as shown in Pic.10).
Put the cabinet in the packing box to prevent it from being soiled or damaged (Pic.6)
Offer the appliance up to the required point of installation and mark, through the fixing holes, the points on
the wall where the holes should be driller for the 4 screw anchors, as shown in Pic. 7.
Remove the appliance from the point of installation; drill the holes where marked on the wall (see Pic. 8)
and insert the screw anchors. Place the appliance against the wall and fix it by tightening the screws into
the anchors see (Pic.9). Carry out the water and electrical connections as described in the relevant
paragraphs.
