HiTRAX PULSE
–
3D Pedometer with clock
HiTRAX PULSE
–
3D Pedometer with clock
15
14
1. Functions
• With 3D sensor - can be placed anywhere (belt, pock-
et, bag...)
• Adjustable step length (cm- inch)
• Clock (12/24 hour format)
• Calorie consumption/ fatburning (kcal – g/oz)
• Distance (km - miles)
• Speed (km/h - m/h)
• Temperature (°C/°F)
• 7-day-storage
• Incl. battery (CR 2032) Nylon case with clip
2. Elements (Fig. 1+2)
A: Display
B: REC/
▲
button
C: SET/TMP button
D: MODE/
▼
button
E:
ON / OFF button
F: Battery compartment
G: RESET button
H: Eyelet for cord
3. Getting started
• Pull off the protection foil on the display.
• Open the battery compartment by turning the lid coun-
terclockwise using a coin and remove the insulation
strip.
• Close the battery compartment again.
• All LCD segments will light up for about a few seconds.
• The unit is now ready to use.
4. Basic setting
• After battery was activated or press and hold SET/TMP
button for 3 seconds, you will enter the basic setting
mode.
• °C flashes on the display.
• Press MODE/
▼
button to change the temperature unit
from °C to °F. In this case the other units change
correspondingly.
• Confirm with SET/TMP button.
• 0:00 (AM 12:00) appears on the display and the hour
digit is flashing.
• Press REC/
▲
button (+ 1 hour) or MODE/
▼
button (-
1 hour) to adjust the hours.
• Confirm with SET/TMP button.
• The minutes are flashing. Set minutes in the same way.
• Confirm with SET/TMP button.
• The step length - adjustment flashes (default: 60 cm/
23.5 in).
• Press REC/
▲
button (+ 1 cm) or MODE/
▼
button (- 1
cm) to adjust the step length.
• Confirm with SET/TMP button.
• The weight - adjustment flashes (default: 50 kg/110 lb).
• Press REC/
▲
button (+ 1 kg) or MODE/
▼
button (- 1
kg) to adjust the weight.
TFA No. 42.2005 Anleitung_02_16 23.02.2016 17:41 Uhr Seite 8
