HiTRAX PULSE
–
3D Pedometer with clock
HiTRAX PULSE
–
3D Pedometer with clock
13
12
• Close the battery compartment again.
• All LCD segments will light up for about a few seconds.
• The unit is now ready to use.
4. Basic setting
• After battery was inserted or press and hold SET/TMP but-
ton for 3 seconds, you will enter the basic setting mode.
• °C flashes on the display.
• Press MODE/
▼
button to change the temperature unit
from °C to °F. In this case the other units change corres-
pondingly.
• Confirm with SET/TMP button.
• 0:00 appears on the display and the hour digit is flashing.
• Press REC/
▲
button (+ 1 hour) or MODE/
▼
button (- 1 hour)
to adjust the hours.
• Confirm with SET/TMP button.
• The minutes are flashing. Set minutes in the same way.
• Confirm with SET/TMP button.
• The step length - adjustment flashes (default: 60 cm/23,5 in).
• Press REC/
▲
button (+ 1 cm) or MODE/
▼
button (- 1 cm)
to adjust the step length.
• Confirm with SET/TMP button.
• The weight - adjustment flashes (default: 50 kg/110 lb).
• Press REC/
▲
button (+ 1 kg) or MODE/
▼
button (- 1 kg) to
adjust the weight.
• Confirm with SET/TMP button.
• The unit is now ready to use.
• Hold and press MODE/
▼
button or REC/
▲
button for a
fast count.
5. Step counting
• Press MODE/
▼
button (3 secondes), if desired, to reset the
day data.
• 0 Step appears on the display.
Caution:
Please note that the first steps do not immediately
appear on the display. The pedometer will start to count
after 10 constant steps and will add on the first steps
directly.
6. Indication temperature
• Press SET/TMP button and the actual temperature appears
on the display (5 secondes).
7. Display
• Press MODE/
▼
button and you can choose between:
■
Calorie consumption and fat burnt display:
KCAL and GM or OZ
■
Distance covered in KM or miles (M)
and the time taken in hours and minutes
■
Average speed KM/H or M/H
• Press MODE/
▼
button again and you will return to nor-
mal mode (STEP and time).
TFA No. 42.2005 Anleitung 16.12.2009 9:52 Uhr Seite 7
