Install Kit E 435/E 435 A 1.0
6
8 Mains Input
Use the factory-included IEC cord to connect this
socket to a wall outlet. Note: The EA 600 IL is
equipped with a V-Lock mains cord retainer. If you
use an optionally available Volex locking cord or
another brand of cord with a compatible design, you
can lock the mains cord in place to prevent accidental
disconnection.
Caution!
Make sure the local mains voltage matches
the voltage specified on the EA 600 IL. Connecting it
to the wrong mains voltage may destroy its electronic components.
2.3 E-Connect
The E-Connect audio bus/ mechanical coupler connects ELEMENTS
components without any additional loudspeaker cords.
The mid/high unit’s E-Connect shaft has a detent button that locks in
place in the other unit’s E-Connect sleeve. This coupler connects the
two components mechanically and the integrated bus routes the audio
signal through without requiring any outside cords. To separate the two
components, press the detent button and disengage the two modules.
3 Mounting
You will need these tools to proceed:
• Phillips head screwdriver
• 13 mm SW open-end wrench
• 5 mm Allen wrench
Mounting units using a) up to four 5 mm
screws or b) one or two 8 mm screws
Screw the two
mounting brackets (2)
to the wall, spacing
them vertically to
match the number
and size of the
Elements module
you want to mount
(see page 3 for
dimensions).
Install Kit for passive
units only: Attach the
terminal block (9) with
the included screw
to the retaining plate
(3), which will later be
mounted on top.
Attach the retaining
plates (3) to the cover
and base of the Install
Kit using the M8 bolts
(8), washers (7) and
spacer sleeves.
Install Kit for passive
units only: Insert the
¼" (6.3 mm) plug into
the mid/high unit’s
E-Connect port.
Now bolt the Install
Kit with the attached
retaining plates (3) to
the mounting yokes.
The four holes let
you adjust the unit to
determine the desired
distance from the
wall.
Align the Install Kit
horizontally to aim the
speakers, and then
tighten all screws.
Install Kit for passive
units only: Connect
a speaker cord (not
included) to the Install
Kit by way of the
terminal block.
Use the M3 screws
(4) to attach the cover
plates to the two
retaining plates.
Mains
Power
Speaker
Out
On
Off
6
7
8
