Control Panel Operation
：
The indicator of POWER will flash after plugged in, and
then the machine enters standby state. It will start to
work by pressing POWER button, accompanying
indicator lighting. During operation, pressing this button,
the machine will return to standby state.
This button is for selecting the size of ice. The default
setting is large ice, if the small one is needed, pressing
this button is available. When you select the desired
size, corresponding indicator of
S
(small) or
L
(large) will
be on.
Press and hold "SELECT" button for 3 seconds to
activate pipeline self-clean process, which takes "pump
water in for 30 seconds---water tank run to drain out
water" as a circle, and this circle will run for 5 times.
Flashing of indicators of "S" and "L" will take place in
turn until self-clean process is over and the machine
enters standby mode. Take away the plastic plug to
drain water and then whole process is finished.
When the indicator of this button turns to red, it means
insufficient water to water reservoir, you need to add
enough water and press POWER button to restart the
machine.
