User Guide | FreeSpeak Edge Base Station
2.6
Stage Announce and Program Feed
Your FreeSpeak Edge Base Station is supplied with an RJ45 connector that uses a splitter
cable to split into two XLR connectors. If you wish to use an external Stage Announce (
SA
) and
Program Feed (
PGM
), you must connect this to the RJ45 port labeled
SA/PGM
(port 8) on the
rear of your device, and connect your input (
PGM
) and output (
SA
) to these connectors.
Navigate to
Configuration > Channels
in the CCM and click the add button
next to the
PGM and SA ports to put them into channels as required. These audio resources can be routed
to
Channels
,
Groups
,
Roles
and
Logic
events (GPIOs).
Note:
These resource are unidirectional (simplex, not duplex).
2.7
Setting the Management IP Address
By default your Base Station works with DHCP IP addressing. However, you can set a static IP
address for any of the station IP ports (with the exception of Dante audio that is defined by the
Audinate Dante Controller).
The Management IP address can be set:
l
From the Base Station front panel menus
l
From the Core Configuration Manager (CCM)
Page 17
Summary of Contents for Clear-Com FreeSpeak Edge
