6
Register each COMMUNICATOR
®
as follows:
Be certain all Communicators to be registered are turned off and
the base station power is on. Other Communicators can be on or off.
Open the base station and locate the items shown in Figure 5.
⎯
Press and release the registration button.
⎯
If no Communicators are on, the status light will be blinking
red. If any Communicators are on, the status light will be on
steady green.
⎯
After you press the registration button, the Communicator ID
display will show a small “o” for open, and the status light will
blink green.
Press and hold the B button while pressing and releasing the
PWR (power) button to turn the Communicator on, and release
the B button. This will cause the Communicator to enter the
registration mode.
⎯
The status light in the base station will be blinking green and the
Communicator ID display will continue to show a small “o” for open.
⎯
The power lights next to the A1 and A2 buttons on the
Communicator will be blinking red then will change to green.
When the registration is successfully completed:
⎯
The green status light in the base station will be on steady and
the Communicator ID display will show the ID number assigned
to this Communicator. ID numbers are assigned sequentially as
0 thru 9, A, b, C, d and E.
⎯
One of the power lights on the Communicator will remain on
steady green.
Figure 5. Registration buttons and indicators
NOTE:
Communicators
must be within 6
feet (1.83 meters)
of the base station
while being
registered.
Communicator ID display
Status light
Reset button
Clear all registration button
Registration button
