12
Message Repeater Operation
(Refer to Figure 2 on page 2)
To record RED MESSAGE
Be certain the RED MESSAGE switch is in the ON position.
Press and release the RECORD MODE button on the base station
once
.
⎯
The
red
MESSAGE RECORD light on the base station will come on.
Press and hold button B on the COMMUNICATOR
®
and talk into the
headset microphone to record a message (up to 8 seconds).
⎯
The MESSAGE RECORD light on the base station will begin blinking.
Release button B.
⎯
The record function will stop and the
MESSAGE RECORD light will go off.
To record GREEN MESSAGE
Be certain the GREEN MESSAGE switch is in the ON position.
Press and release the RECORD MODE button on the base station
twice
.
⎯
The
green
MESSAGE RECORD light on the base station will come on.
Press and hold button B on the Communicator and talk into the
headset microphone to record a message (up to 8 seconds).
⎯
The MESSAGE RECORD light on the base station will begin blinking.
Release button
B
.
⎯
The record function will stop and the
MESSAGE RECORD light will go off.
Locate the RED MESSAGE and GREEN MESSAGE switches, and
the RED MESSAGE CONTROL and GREEN MESSAGE CONTROL
DIP switches inside the front door of the base station for the
following settings.
Red Message Switch
In the
ON
position, the RED MESSAGE switch enables the “Red
Message” to be played. A playing message can be cancelled by
pressing Communicator button A.
Red Message Control
Switch 1
enables inbound audio from speaker post to be heard
while message is playing.
Switch 2
enables message to be played to all Communicators.
Switch 3
enables message to be played on the outside speaker.
Switch 4
enables message to be played on the ceiling speaker.
Switch 5
causes message to be triggered by an external alert signal.
Switches 6, 7
and
8
not used
Green Message Switch
In the
ON
position the GREEN MESSAGE switch enables the
“Green Message” to be played. A playing message can be
cancelled by pressing Communicator button A.
Green Message Control
Switch 1
enables inbound audio from speaker post to be heard
while message is playing.
Switch 2
enables message to be played to all Communicators.
Switch 3
enables message to be played on the outside speaker.
Switch 4
enables message to be played on the ceiling speaker.
Switch 5
causes message to be triggered by an external alert signal.
Switch 6
causes a 3 second delay before message is played.
Switch 7
not used
Switch 8
allows selection of single or dual-beep vehicle present tone.
NOTE:
If both RED
MESSAGE and
GREEN MESSAGE
switches are in the
ON position, and are
selected for the
same output, Red
and Green
Messages will be
played alternately.
After a new
message has been
recorded or after the
base station has
lost and regained
power, any
message to the
outside speaker will
always be heard in
the Communicator
headset the first
three times it plays,
whether Switch 1 is
in the ON or OFF
