1) DESKTOP
You can use your transmitter with the 20 degree wedge attached or remove the
wedge and lay the transmitter flat.
2) WALL MOUNT
To mount your transmitter on a wall
Remove the plastic bracket (included) under the transmitter unit by
unlocking the 2 latches
Place the plastic bracket against the wall and with the aid of a pencil, mark
the position of the mounting holes. (Refer to figure below) Mount the
transmitter in a convenient location where a power outlet is available.
Drill a hole on the market position. Install the 3 mounting screws (and use
anchors where necessary) Ensure that the screws are not fully tightened so
that the unit can be easily removed from the wall.
Place the transmitter onto the wall (without the plastic bracket) Plug the 2-
amp wall transformer into any suitable AC outlet. Plug the power connector
into the power jack on the top left hand side of the unit. Transmitter is now
ready for use. Be certain to mount the transmitter away from phones, heat,
moisture and exposed power circuits. These items can damage your system
and shorten transmission range.
3) SYSTEM CONFIGURATION
Your system was set at the factory and will function as soon as it is powered up.
Default setup is as below:
Current time
Sleep shutdown - OFF
Range Test - OFF
Default Alert Type - Vibe only
Duty Alert - OFF
Out of Range – OFF
Baud Rate – 1200 BPS
Transmission Frequency - 9 kinds selectable
3. System Programming (Transmitter Version 1.01A)
To enter programming mode, press the “SETUP” button and enter the password
‐ This device doesn't support two‐way paging.