INSTRUCTION MANUAL
ART.-NO.: 46153
6. Opening the safe with personal PIN code
Enter your PIN code (3 - 8 digits) and confirm with button “A” or “B” (
Figure 4). The green LED lights up. Now push the
handle downwards and pull the safe door open.
7. Automatic lock
Three continuously wrong entries will activate automatic lock of the safe for 20 seconds.
Six times wrong entries will activate automatic lock of the safe for 5 minutes.
During the blocking time, the yellow LED flashes and the keypad is locked.
8. Battery replacement
To replace the batteries, open the battery compartment on the inside of the safe door.
Note:
Please do not mix old and new batteries or different battery types.
ACHTUNG!
When you replace the batteries, the stored PIN codes are deleted. After replacing the batteries, please save
the PIN codes as described in 4. Storing the personal PIN code and 5. Storing the second personal PIN code. When the
batteries are empty, the safe can only be opened with the emergency key.
© Holthoff Trading GmbH
HMF
.DE | service@hmf.DE
Floor mounting
cover
emergency
lock
inside safe door
reset-button
yellow LED
green LED
handle
keypad
red LED
battery compartment
Loosen the Allen screw on the bottom of the safe
using a 10 mm Allen wrench. Remove the floor
anchoring from the bottom of the safe.
Use the screws supplied to fasten the anchoring
device to the desired location on the ground.
Place the safe on the ground anchoring and
fasten the Allen screw from the inside.
1
2
3
Figure 2
Figure 3
Figure 4
