INSTALLATION INSTRUCTIONS
TRU-FIT
DOOR & PANEL
FIGURE 13
STEP 13
Set Wood Block on center of base for spacing and safety. Set the Glass
Door (O) on top of Wood Block (U) and position Hinge Jamb (B) to go
over the Wall Jamb (A). USING TWO PEOPLE (1 PERSON INSIDE,1
PERSON OUTSIDE), slide Hinge Jamb (B) over Wall Jamb (A) carefully
until fully compressed. (See Figure 13) Wood Block should still be under
the Glass Door (O).
ONCE COMPLETED, DO NOT LEAVE DOOR UNATTENDED,
IT COULD STILL FALL!
STEP 14
Note that the Glass Door (O) and Glass Panel (P) are setting in
place, while one person steadies the door the other can adjust
both pieces of glass so that you have about 1/8” gap between glass
panels. (See Figure 14) (1/8” is recommended to reduce leakage,
but can be larger if desired). It is ideal to adjust a little in both
door and panel instead of pulling all the adjustment out of one or
the other (depending on your size, you might have to fully adjust
both to ensure proper fit). Make sure that the 1/8” gap is uniform
the entire length of the door. Make sure the door is level before
drilling holes. (See Figure 14)
FIGURE 14
ADJUSTMENTS
FIGURE 15
STEP 15
Once adjusted, take a 1/8” drill bit and place in pre-drilled holes on
Hinge Jamb (B). Drill three pilot holes through the Wall Jamb (A).
(See Figure 15)
V5_21_26
