ASSEMBLY STEP 5,6 AND 7
Assembly step 5
Align the
#9-bracket
with the
#7- pallet support tube
hole and use the
#10-5 hex wrench
to lock the two
#20-
hexagonal flat head screws M8*15
clockwise. Loosen the plum blossom elastic knob on the
#2-support tube
,
insert the
#7- pallet support tube
into the
#2-support tube
, adjust to the appropriate gear position, and
tighten the plum elastic knob to fix it.
Assembly step 6
Disassemble the
#6-foam tube
, as shown in the figure, insert the
#2-support tube
and
#3-hook tube
, and
insert the foam and the plug at both ends.
Assembly step
7
Disassemble the
#8-limit bar
, as shown in the figure, insert different hole positions to adjust the position of
the hook tube, which is more suitable for ergonomic size. At this point, the assembly is complete.