5.9.8. WLAN Advanced Settings
Figure 14. WLAN Settings page
Advanced Settings
Setting
Description
Bridge Mode
Layer 2 tunnel: All layer 2 data will be bridged over WLAN. Use when multiple devices on both sides of an Ethernet
network bridge must be able to communicate via WLAN (many-to-many). Only works between Anybus Wireless Bolt
or Wireless Bridge II devices.
Layer 2 cloned MAC only: Layer 2 data from only a single MAC address (specified below) will be bridged over WLAN
(many-to-one).
Layer 3 IP forward: Default setting. IP data from all devices will be bridged over WLAN. This mode must be used
when using the DHCP Relay function. See
Layer 3 IP Forward Connectivity Considerations (page 23)
.
Cloned MAC Address
The MAC address to use with Layer 2 cloned MAC only.
Cloned IP Address
The IP address to use with Layer 2 cloned MAC only.
Anybus
®
Wireless Bolt Serial
™
Configure Settings in the Built-In Web Interface
Page 28 of 60
SCM-1202-143 2.0