5 (26)
2
Installation
2.1
Basic Installation Steps
This product contains parts that can be damaged by electrostatic discharge (ESD).
Use ESD protective measures to avoid equipment damage.
Connecting power with reverse polarity or using the wrong type of power supply
may damage the equipment. Make sure that the power supply is correctly
connected and of the recommended type.
Make sure that you have all the necessary information about the capabilities and restrictions of
your local network environment before installation.
1.
Mount the unit on a flat surface or on a DIN rail using the adapter kit (optional).
2.
Connect the slave devices and/or Ethernet network as needed.
3.
For mobile networking (EC350), connect the mobile antenna and insert the SIM card.
4.
Connect a suitable power supply and apply power.
5.
Configure the unit.
Modbus Interfaces
Modbus devices can be connected to more than one interface and/or physical connection on
Netbiter EC300 Series gateways. These interfaces must also be enabled in Netbiter Argos be-
fore they can be used. See the Netbiter Argos documentation for more information.
2.2
Factory Reset
Keep the
MODE
button pressed while powering on to reset to the factory default settings.
Fig. 1
Factory reset
Netbiter EC300 Series User Manual
SCM-1202-012
2.2
