6. Install the Pedal Support Tube (Left & Right)
a. Insert the left Pedal support tube (4) through the
Rear clip bracket (35), a Wave washer (28) and
Pedal axis bushing (54) into the Left pedal axis
(30).
b. Attach the pedal axis (30) to the crank (67) and
tighten them with Power support pole and left
lock nut. Do the same steps as above to
assemble the right Pedal support tube (4) to the
right pedal axis (30). (Refer figure 6)
7. Install the Pedals
Attach the left Pedal (5) to the left Pedal support
tube (4) with four M8x50 Bolts (37),
ф8 Flat
washers (50), and M8 Lock nuts (42). Do the same
steps as above to assemble the right Pedal (5) to
the right Pedal support tube (4).
(Refer figure 7)
8. Install the Handlebar (Left & Right)
Insert the Left handlebar (8) to the left Handlebar support
(6L) with four M8x40 Bolts (33), Arc washers (45),
ф8
Spring washers (51), and M8 Cap nuts (40). Do the above
same steps to assemble the right handlebar (11) to the right
Handlebar support (6R). (Refer figure 8)
Note: The bolt must be set into the hexangular hole.
9. Install the nut cap
After installed and adjusted the equipment, at the
connecting of
U-shape bracket and Handlebar support, clip on the cap
nut (Refer figure 9)
COMPUTER OPERATION
