FUNCTIONS
1. SPEED/BODYFAT RATIO/RPM (IF HAVE)
(
Display in A Window
)
I. Display instantaneous speed and the range is 0.0~99.9KM/H.Or,if the monitor showing M, the
range will be 0.0~99.9MILE/H.The max. pickup signal is 1500rpm.
ii. Display current repetition per minute (RPM) during exercise. It reflects the pedal frequency.
The range is 0~1500 rate per minute. (IF HAVE)
iii. Display Body fat ratio.
2. TIME/BMI
(
Display in B Window
)
I. Count the total time from exercise start to the end and the range is 0 ~ 99M59S.
ii. Exercise time can be set in advance, when it approaches the preset time, the monitor will
alarm 10 seconds. The maximum pre-set time is 99 minutes.
iii. Display Body Mass Index (BMI).
3. DISTANCE/BMR
(
Display in C Window
)
I. Count the total distance from exercise start to the end and the range is 0.00 ~ 9.99 ~
99.9KM.Or, if the meter showing M, the range will be 0.00 ~ 9.99 ~ 99.9 MILE.
ii. Exercise distance can be set in advance, when it approaches the preset distance, the monitor
will alarm 10 seconds. The maximum pre-set distance is 99.9KM or MILE (if the monitor
showing M).
iii. Display Basal Metabolic Rate (BMR).
4. CALORIES/TEMPERATURE
(
Display in D Window
)
I. Count the total calories consumed from exercise start to the end and the range is 0.0 ~ 99.9 ~
999KCAL.
ii. The calorie value can be set in advance, when it approaches the preset calorie, the monitor
will alarm 10 seconds.
iii. Display room temperature (TEMP)
5. PULSE
(
Display in E Window
)
I. Measure your heart rate per minute. The range is 40 ~ 240bpm.
ii. It will display “P” to pause the pulse test if there is no pulse signal over 60 seconds. You can
press UP or DOWN to enter the pulse test again.
6. WHEEL DIAMETER
The wheel pe
rimeter has been set according to client’s requirements.
7. ALARM
The monitor will “Beep” when press “MODE” “RECOVERY/UP” “DOWN”, RESET/GO or
“BODYFAT” buttons.
8. AUTO ON/OFF & AUTO START/STOP
I. Without any signal of exercise or operation for 8 minutes, the power will turn off automatically
and all the memory will be cleared off except body fat parameters and temperature.
ii. Once receive exercise or operation signal, the monitor will turn on automatically.
ATTENTION: the information only can be recovered in 15 seconds after battery replacement;
the built-in data in computer may be lost after battery replacement; the normal life for battery
is one year.
Summary of Contents for H9244
Page 1: ...H9244 INSTRUKCJA U YTKOWANIA MANUAL INSTRUCTION N VOD K OBSLUZE...
Page 5: ...NARZ DZIA 91 10 Podk adka 4pcs...
Page 18: ...TOOLS...
Page 37: ......