b. Connect the computer wire (26) to the Sensor wire (25) coming out from mainframe (1) as
show on drawing
D
of figure3.
c. Insert the Front upright frame (14) to the main frame (1) and secure it with six pieces of M8 x
20 Bolts (38),
Φ8 Spring washers (51), and Φ8 Arc washers (45) as shown on drawing
D
of
figure 3.
4). Install the Hand Pulse Bar
a. Insert the hand pulse wires (24) from hand pulse bar (20) into the hole on the back of Front
upright frame (14) and then pull them out from the upper hole of Front upright frame (14).
b. Attach the hand pulse bar (20) to the groove of Front upright frame (14) with two pcs of
Φ8
arch spacers (45), and M8 x 16 bolts (93). (Refer figure 4)
5)
.
Install the
Computer
a. Connect the Pulse wires (24) with Sensor wire 2 (26) and put the extra wires into the tube.
b. Attach the Computer (10) to the top of the Front upright frame (14) and tighten with
Crosshead bolt M5 x 10 (75). (Refer figure 5)
Summary of Contents for H9249 Series
