20
M2218
7. Attach the pedal
Attach the pedal strap
(33R)
to the pedal
(34R)
.
Do the same procedure for left pedal strap
(33L)
and left foot pedal
(34L)
assembly.
NOTE: The end with four adjustable holes must be set outwards.
The axle of foot pedals
(34R/34L)
and crank arms
(45)
are marked with
“R”
&
“L”
(right and left ).
Connect each pedal
(34R/34L)
to the matching crank arm
(45)
.
NOTE:
The right pedal
“R”
should be threaded on clockwise.
The left pedal
“L”
should be threaded on
counter-clockwise.
Computer
MAIN LCD DISPLAY AREA:
3.
The LCD display TIME, SPEED, DISTANCE, CALORIES, PROGRAM, and PULSE .
4.
Use the MODE, SET UP and DOWN buttons to select a program and time .
LCD FEATURES:
SCAN:
Automatically scans each function of
TIME,SPEED,DISTANCE,CALORIE, PROGRAM, and PULSE in
sequence with change every 5 seconds.
NOTE:
If you do not want to use the SCAN function, press the
MODE button to select one of the other functions.
TIME:
Displays the time, from one sec up to 99:59 minutes.
SPEED:
Displays the current speed, from zero to 999.9 Kilometer per
hour.
DISTANCE:
Displays the distance, from zero to 99.99 Kilometer.
NOTE:
The LCD will display an image of a bike. This bike will
travel around the window in a clockwise direction to track the
distance the user has traveled. One lap is 0.2 miles.
CALORIE:
Displays the calorie consumption, from zero to 9999 cal.
The calorie readout is an estimate for an average user. It
should be used only as a comparison between workouts on
this unit.
PROGRAM:
Displays programs for selection during setup, from P0 to P6.
Displays the current load level during exercise of the programs
from L1 to L8 (level 1 to level 8).
PULSE:
Displays the pulse rate in beats per minute, from 40 to 240
beats per minute.
NOTE:
You must place both of your hands on the Pulse Sensors on the
handlebar to input the pulse signal. If you do not place your hands correctly and 8 seconds passes without a pulse
input, the computer will turn off the pulse circuit. This is a power saving measure and you can press MODE button
to restart the pulse function.
LOAD INDICATOR BAR:
Displays the current working load level with a block bar. Each block on the represents one load level. The block
bar will change during the workout based on your preset program time.
Summary of Contents for M2218
Page 5: ...5 M2218 Diagram zbiorczy...
Page 17: ...17 M2218 Explode View...
Page 26: ...26 M2218 Mont n n kres...
Page 30: ...30 M2218 N KRES...