ASSEMBLY INSTRUCTIONS
STEP 1.
First set the decorative cover into the upright assembly (9), then insert the upright
assembly into the glass base assembly (12), finally lock the upright by using the
screw M8*15
（
6
）
and arc washer
φ
8
（
7), covered the decorative cover.
STEP 2.
First put the power line(2) from top to massage head fixed (3) and
pull out the power line plug; then put the massage heads parts from
top into holes on the fixed plate of massage head fixed, use M6
screw(5) and 6# flat washers to lock the massage head assembly(1)
by using Z-shaped wrench.
STEP 3.
First put the power line(2) from top to the uprights
assembly(9) and the glass base assembly(12), pull out
the power line plug from the glass base; then insert the
assembled massage head assembly into upright(9), turn
the elastic pin(21) to the upright assembly(9), only to
spin into 3-5 teeth, then a hand pull out elastic pin(21),
the other hand adjust the left and right and up and down
position of massage head assembly(1) to make one of
adjustment holes aim bolt hole, release the elastic
pin(21) and spin tight.
Summary of Contents for MA1001
Page 24: ......
