8.
WATT :
When entering WATT program, the preset watt value 120 is flashing on screen to be set. User may use UP, DOWN button
to set target value from 10 to 350. Press MODE button for confirm. Press UP or DOWN to preset TIME. Press START/STOP
button to start or stop workout.
9.
BODY FAT:
9-1 In STOP mode, press the BODY FAT button to start body fat measurement.
9-2 Then selected user (U1~U4) will blinking for 2 seconds. Then start measuring.
9-3 During measuring, users have to hold both hands on the handgrip. And the LCD will display “--” “--“for 8 seconds until
computer finish measuring.
9-4 LCD will display BODY FAT advice symbol, BODY FAT percentage, BMI for 30 seconds.
10. RECOVERY:
After exercising for a period of time, keep holding on handgrips or wear chest belt. When there is pulse figure displayed,
press “RECOVERY” button. All function display will stop except “TIME” starts counting down from 00:60 to 00:00.
Screen will display your heart rate recovery status with the F1, F2….to F6. F1 is the best, F6 is the
worst. User may keep exercising to improve the heart rate recovery status.
(Press the RECOVERY button again to return the main display.)
NOTE:
4.
The console is for self-generating system, so user must pedal and keep RPM >15 to power on the console.
5.
When there is no RPM signal input for 90s, LCD will be off ; While there is sensor input and RPM> 15,console will reboot.
6.
When computer act abnormal, please plug out the adaptor and plug in again.
MALFUNCTIONS AND TREATMENT
Malfunction
Reason
Treatment
Base is unstable.
1. Floor is not flat or there is small
object under the front or rear
stabilizer.
2. The rear base feet have not been
leveled when assembling.
1. Remove the object.
2. Adjust the rear base feet.
Handlebar or seat
cushion is shaking.
The screws and round knob are loose.
Tighten the screws and round knob.
Loud noise from the
moving parts.
The interval of the parts is improper
tighten.
Open the covers to adjust.
