16
V. Parameters instructions
○- Parameters that can be modified in any state
× -Parameters that cannot be modified in the running state
◆
-Actual detection parameters, which cannot be modified
◇
-Manufacturer parameters, which are only modified by the manufacturer, and users are forbidden to modify them.
00 groups-basic operating parameters
Function
code
Name
Content
Setting range
Factory
setting
Change
00.00
Function macro
definition
(temporarily
reserved)
0: General model
1: Single pump constant pressure water supply mode
2: Reserved
3: Reserved
4: Engraving machine mode
5: Reserved
6: Reserved
7: Reserved
8: Reserved
9: Reserved
10
：
Reserved
0
～
10
0
×
00.01
Motor control
mode
0: VF control
1: Advanced V/F control
2::Vector control
0
～
2
0
×
00.02
Run command
channel selection
0: Keypad
1: Terminals
2: Communication
0
～
2
0
○
00.03
Frequency given
selection
0: Keypad potentiometer
1: Digital given 1, adjust with ▲ and ▼ keys on the operation panel
2: Digital setting 2, adjust with terminal UP/DOWN
3: AI analog setting (0
～
10V/0
～
20mA)
4: Combination setting
5: Reserved
6: Communication
7
：
Reserved
Note: When combination given time is selected, the combination given
mode is selected in 01.15.
0
～
7
0
○
00.04
Max output
frequency
The maximum output frequency is the highest frequency allowed by the
inverter, and it is the benchmark for setting the acceleration and
deceleration time.
MAX
｛
50.0,
【
00.05
】
｝
～
999.9Hz
50.0Hz
×
00.05
Upper limit
frequency
Operating frequency cannot exceed this frequency
MAX{0.1
，
【
00.06
】
}
～
【
00.04
】
50.0Hz
×
00.06
Lower limit
frequency
Operating frequency cannot be lower than this frequency
0.0
～
upper limit
frequency
0.0Hz
×
00.07
Lower limit
frequency arrival
processing
0: Zero speed operation
1: Running at the lower limit frequency
2: Stop
0
～
2
0
×
00.08
Digital setting of
operating
frequency
This set value is the initial value of frequency digital given
0.0
～
upper limit
frequency
10.0Hz
○
