OM-498 Page 26
7-4.
Adjusting Engine Speed (Kohler-Powered Units)
802 512-A / Kohler Dwg.
After tuning engine, check engine
speeds. See table for proper no
load speeds. If necessary, adjust
speeds as follows:
Start engine and run until warm.
Weld/Power Speed
Adjustment
1
Throttle Control Lever
2
Adjustment Screw
Move lever to Run (far right) posi-
tion. To increase speed, turn screw
out (counterclockwise) while lightly
pushing lever to the right. To de-
crease speed, turn screw in (clock-
wise).
Idle Speed Adjustment
3
Adjustment Screw
Move lever to idle (far left) position.
To increase idle speed, turn screw
in (clockwise). To decrease idle
speed, turn screw out (counter-
clockwise).
Stop engine. Close fuel
valve.
Tools Needed:
2000
±
150 rpm
3720
±
50 rpm (60 Hz)
3
Top View
Top View
1
2
Summary of Contents for 1435
