13
NOTES:
x
If a value has been assigned for a step number, that LED will be lit.
x
The LED for the selected step will blink.
x
If the default value is still assigned to a step, the LED will not be lit.
x
When programming, the Recipe and Time Selectors are disabled.
SPEED SETTINGS
TIME SETTINGS
SPd 1 (DEFAULT)
00:00 – 15:00 minutes (10 second increments)
SPd 2
End (default)
SPd 3
Stir
PAUS (pause – no mixing)
5.
Use arrows to select step number (1 – 5).
6.
Press SPEED. All characters will blink and buzzer will sound.
A.
Use arrows to select the mixing speed for selected step.
B.
Press SELECT/SAVE to set the speed. SAVE displayed momentarily and buzzer sounds.
7.
Display alternates between speed and time to indicate programming mode.
8.
Press TIME. Third digit will blink and buzzer will sound.
A.
Use arrows to select the mixing time (increments of 10 seconds) for selected step.
NOTE:
If all 5 steps are programmed, the recipe will terminate at the end of step 5. If fewer than 5
steps are used, the default time setting of END will terminate the recipe.
B.
Press SELECT/SAVE to set the time for the step. SAVE momentarily displayed and buzzer
sounds.
9.
Display alternates between speed and time to indicate programming mode.
NOTE:
LED of step programmed will be flashing.
10.
Use arrows to select next step.
11.
Repeat setting speed and time for additional steps and use SELECT/SAVE to save settings.
12.
After all steps for recipe are programmed, press PGM to exit programming mode.
Buzzer sounds and display will show recipe number that was programmed with the number
blinking.
13.
Press PGM to enter run mode. (Buzzer sounds)
14.
Press STD to return to standard mode or set recipe selector to the desired recipe.
15.
Select the recipe that you programmed and verify proper operation.
