(19) Use PlastiZap and glue the three plastic push rod exits to the fuselage
(22) Install the plastic tubing through the hole in the firewall to the servo tray Epoxy
the tube where it goes in
(20) Check to make sure that the rods will easily move in and out with little
resistance You may have to bend the rods slightly for a perfect fit (We will
connect the rods to the servos after the tail assembly )
(23) Make a "Z" bend on one end of the throttle control rod and insert the opposite
end into the tube
(21) Use the throttle control rod and the white throttle tube for the engine linkage
Lightly sand the plastic tube so the epoxy will adhere to it
(24) Connect the servos to the receiver and battery and center all radio controls
(including the throttle stick and move the servo horns so they are in line with
the servo as shown After they are centered pull the throttle stick back down
(low throttle) Install the straight servo horns
-16-
