10
REPLACEMENT PARTS
1. Propeller Shaft Bearings 1.5x4x2mm (4)
2. Propeller Set (4)
3. Propeller Guard Set (4)
4. Crown Gear w/Shaft Set(2)
5. A/B Motors w/Pinions (2)
6. Arm Set A/B (2)
HCAE6055
HCAE6301
HCAE6302
HCAE6350
HCAE6340
HCAE6370
Not Pictured:
Wall Adapter 100-240V 2A
Charging Box w/USB Cord
Battery 900 MAh
Replacement Parts:
HCAE6310
HCAE6311
HCAE6320
2
4
5
3
1
1
6
6
6
6
6
6
Short Gearshaft: A Arms
Long Gearshaft: B Arms
MAINTENANCE
Propeller Installation
Be sure to match the letter on the
propeller with the letter on the arm.
Motor/Gear/Bearing Replacement
The Motor, Gear, and Bearings can be replaced without removing
the arm from the Flitt. Remove the 6 screws on the arm cover and
replace the damaged part(s).
NOTE:
The “A” arms use the shorter
gearshaft and the “B” arms use the longer gearshaft.
Arm Replacement
1. Remove the parts from the damaged arm.
2. Remove the 4 large screws from the frame below each arm.
3. Carefully separate the cover from the frame enough to allow
the arm to be removed.
4. Remove the motor wire from the slot in the damaged arm.
5. Remove the damaged arm from the frame.
6. Install the new arm and reverse these steps.
Flitt Settings Reset
To reset the settings on the Flitt to
factory defaults, press the Reset
Button inside the arm storage
area on the left side of the Flitt (the
Flitt will need to be upside down
to do this). Resetting to factory
default will also restore factory
Wi-Fi name and password.
