ASSEMBLY OF YOUR ELECTRIC FREE-FLIGHT DUCTED FAN AIRPLANE
WARNING: Read instructions carefully! Improper use of this product may result in personal injury or damage to the public.
WARNING: CHOKING HAZARD - Small parts. Not
for children under 3 years. Use with adult supervision.
Replacement Parts
HCAP9905 Charger
HCAA3360 Complete Wing / Tail Assembly
Replacement Parts
HCAP9905 Charger
HCAA3364 Complete Wing / Tail Assembly
Replacement Parts
HCAP9905 Charger
HCAA3368 Complete Wing / Tail Assembly
CHARGING
1. Remove the back cover of the charger and
install 4 “AA” batteries according to the
diagram in the charger. Put the cover back on
the charger. CAUTION:
Do not
use
rechargeable (nickel cadmium) batteries.
Do not mix old and new batteries. Do not
mix alkaline, standard (carbon zinc), or
rechargeable (nickel cadmium) batteries.
2. Before charging your free-flight ducted
fan airplane, make sure the “on-off” switch
is in the “off” position.
3. Insert the charger into the charge socket on
the top of the airplane. The charger will only fit
one way so match the tab on the charger with
the notch on the charge socket.
4. On the first charge, only charge the
airplane for 15 seconds. For longer flights,
you may increase the charge time up to 60
seconds.
5. Never charge the airplane for more than
60 seconds. If you do, you may overheat the
batteries in the airplane or the charger and
damage them.
6. When charging is complete, remove the
charger.
CAUTION: Do not put fingers or objects,
close to or in the ducted fan unit when
running.
HCAZ3104 for HCAA0360/0361/0362
Entire Contents © Copyright 2000
WARRANTY
Hobbico, Inc. guarantees this kit to be free of defects in both material and workmanship at the date of purchase. This warranty does not cover any component parts damaged
by use or modification. In no case shall Hobbico's liability exceed the original cost of the purchased kit. Further, Hobbico reserves the right to change or modify this warranty
without notice. In that Hobbico has no control over the final assembly, no liability shall be assumed nor accepted for any damage resulting from the use of the final
user-assembled product. By the act of using the user-assembled product the user accepts all resulting liability. If the buyer is not prepared to accept the liability associated
with the use of this product, the buyer is advised to immediately return this kit in new and unused condition to the place of purchase. Please inspect all parts carefully before
starting assembly! If any parts are missing, broken or defective, or if you have any question about the assembly or flying of this airplane, please call us at (217) 398-8970 and we will
be glad to help.
A6 Intruder – HCAA0360
A6 Saber Strike – HCAA0361
A6 Voodoo – HCAA0362
• Remove the backing paper from the double sided tape on the
underside of one wing and wing mounts on the fuselage. Align the
front of the wing to the front of the wing mount. Make sure the wing
is against the fuselage and on the double-sided tape. Note the
direction of the main wing before mounting. The control
surfaces should be facing the tail.
• Repeat step 1 for attaching the other wing.
①
①
INSTALL THE MAIN WINGS
• Remove the double-sided tape from the tail section of the fuselage.
Note: The control surfaces (indentations) should be at the back of
the tail. Using the cutouts on the tail, center and align the horizontal
tail to the fuselage. Press the horizontal tail against the double-
sided tape on the fuselage.
②
②
INSTALL THE TAIL
