ASSEMBLY OF YOUR ELECTRIC FREE-FLIGHT REVOLT
™
WARNING: Read instructions carefully! Improper use of this product may result in personal injury or damage to the public.
WARNING: Choking hazard - Small parts. Not for children under 3 years. Use with adult supervision.
Replacement Parts
HCAP9904 Charger
HCAQ3304 Propeller (2)
Requires 4 “AA” Alkaline Batteries (Not Included)
HCAA0311
™
1. Remove the back cover of the charger
by removing the screw and install 4 “AA”
batteries according to the diagram in the
charger. Put the cover back on the
charger and re-install the screw.
CAUTION: Do not use rechargeable
(nickel cadmium) batteries. Do not mix
old and new batteries. Do not mix
alkaline, standard (carbon zinc), or
rechargeable (nickel cadmium) batteries.
2. Before charging your free-flight Revolt,
make sure the “on-off” switch is in the “off”
position. The “off” position is towards the
front of the plane.
3. Insert the charger into the charge
socket on the top of the Revolt. The
charger will only fit one way so match the
tab on the charger with the notch on the
charge socket.
4. Push and hold the charge button on the
charger. On the first charge, only charge
the Revolt for 15 seconds. For longer
flights, you may increase the charge time
up to 60 seconds.
5. Never charge the Revolt for more than
60 seconds. If you do, you may overheat
the batteries in the Revolt or the charger
and damage them.
6. When charging is complete, remove the
charger from the Revolt.
CAUTION: Keep fingers, face, clothing
and other objects away from the propeller
when running.
CHARGING
HCAZ3045 for HCAA0311
Entire Contents © Copyright 2004
WARRANTY
Hobbico, Inc. guarantees this kit to be free of defects in both material and workmanship at the date of purchase. This warranty does
not cover any component parts damaged by use or modification. In no case shall Hobbico’s liability exceed the original cost of the
purchased kit. Further, Hobbico reserves the right to change or modify this warranty without notice. In that Hobbico has no control
over the final assembly, no liability shall be assumed nor accepted for any damage resulting from the use of the final user-
assembled product. By the act of using the user-assembled product the user accepts all resulting liability. If the buyer is not
prepared to accept the liability associated with the use of this product, the buyer is advised to immediately return this kit in new
and unused condition to the place of purchase.
™
