Welcome to the world of R/C Aero modeling. You will
find your new hobby to be exciting, very interesting,
and most of all, a lot of fun. You have purchased, quite
possibly, the best flying, the most reliable, and the
easiest flying R/C airplane available today. Be sure to
follow the written instructions and the video
instructions completely and in detail, doing this will
assure you a successful first flight and many continued
hours of enjoyment from your new R/C hobby.
❏
1. Locate the fin, the fuselage, the horizontal stabilizer
and the wrench.
❏
2. Remove the small nuts and washers already placed on
the threaded shafts located on the bottom of the fin.
❏
3. Carefully place the threaded shafts through the holes
in the horizontal stabilizer as shown in the photo above.
Note:
Make sure the fin is placed through the horizontal
stabilizer with the decals up as shown above.
❏
4. Insert the horizontal stabilizer/fin combination
through the holes in the tail boom as shown in the
above photo. Make sure you place the fin on the top of
the horizontal stabilizer by checking that the decals are
on the top side of the horizontal stabilizer. It is also
important to make sure that the fin fits completely flat
against the horizontal stabilizer.
❏
5. Replace the nuts and washers onto the threaded
shafts that extend below the tail boom using the wrench
supplied with the model. Do not overtighten these nuts;
this could damage both the horizontal stabilizer and the
INSTALL THE HORIZONTAL
STABILIZER & FIN
ASSEMBLY INSTRUCTIONS
4
