❏
1. Turn the plane upside-down. Remove the stabilizer
cover by unscrewing the two medium screws in the
bottom of the cover.
❏
2. With the plane still upside-down, position the
stabilizer on fuselage, with the decal side down, so that
the two holes in the stabilizer align with the two
mounting holes in the fuselage.
❏
3. Position the stabilizer cover over the stabilizer,
aligning the two holes in the cover with the two
mounting holes in the fuselage. Secure the stabilizer
cover to the fuselage with two medium size screws. Be
careful to not overtighten the screws.
❏
4. Turn the plane right-side up. Remove the screw in
the fin mount located on the top of the aft end of the
fuselage. Insert the fin in the mount, making sure it is
fully seated. Reinstall the screw from the left side,
through the fin mount and fin. Be careful to not overtighten
the screws and crush the fin.
❏
At the front edge of the main wing you will notice a
small plastic post. To install the wing, push the post into
the hole in the fuselage. Fasten the wing to the fuselage
with the large screw. Be careful to not overtighten the screw.
INSTALL THE MAIN WING
INSTALL THE STABILIZER & FIN
4
